System Nylonslide 10mm

Introduction to System Nylonslide 10mm

Suitable for glass up to 1.5m high this system is available in polished aluminium, silver anodised or powder coated. Can be supplied in cut lengths up to 4m or in 2m or 4m stock lengths. Glass panels slide on nylon rollers which are incorporated into the bottom track while the top of the glass is supported in the top track. This system is suitable for use in display cabinets, showcases or serving hatches where 10mm glass is required.

The usual overlap allowed between two glass doors is 26mm. For glass sizes deduct 24mm from the height of the opening. For safety reasons we recommend all glass should have polished edges. Please check with your glass merchant to ensure that the speciļ¬cation of the glass is suitable for the particular installation.

For side channels or draught excluders deduct 40mm from the height of the opening. The maximum recommended height to width ratio per door is 1.5:1.

W68

Double bottom track incorporates nylon rollers on which the glass panels run. Supplied drilled and countersunk for fixing. Polished aluminium. Anodised in gold, silver or bronze or black powder coated.

W70

Double top track/side channels can be used either to guide the top of sliding glass doors or for a sliding glass door to locate into at the side of an opening. Supplied drilled and countersunk for fixing. Polished aluminium. Anodised in gold, silver or bronze or black powder coated.

W436

Single top track/side channels can be used for a sliding door to locate into at the side of the opening. Alternatively can be used to frame a fixed panel. Supplied drilled and countersunk for fixing. Polished aluminium. Anodised in gold, silver or bronze or black powder coated.

W359M

Medium round finger pull fits into 38mm diameter hole drilled in glass. 25mm finger hole. Polished aluminium. Anodised in gold, silver or bronze or black powder coated.

W557

Clear plastic draught excluder clips onto edge of glass panel to prevent draughts and dust. For use with W68/W70 track. Supplied in 2m or 4m stock lengths or cut lengths up to 4m

Can't find exactly what you are looking for? That is OK, because if you send us a drawing we will be able to make it for you.
Find out more